How to Enter Fastboot Mode on Xiaomi (2024)

Experienced users can perform serious actions with their smartphones. For example, to install new firmware and roll back to the previous version. Such operations require logging into Fastboot. If you do not know how to enter Fastboot mode on Xiaomi, read this article. Here you will find step-by-step instructions with detailed explanations.

What is Fastboot Mode on Android?

Fastboot is an advanced boot mode for Android smartphones that allows you to use your computer and command line to change important system parameters in your mobile device. Namely:

flashing to the official or custom firmware;
bootloader activation;
rollback to the previous build;
installation of custom recovers.

Fastboot mode on Xiaomi is often used to reflash the smartphone, along with the custom recovery. Boot mode allows you to restore the device if it is stuck on the logo or constantly reboots (boot loop state).

How to enter Fastboot on Xiaomi (MIUI)

First, we carry out two preparatory procedures – enable USB debugging and download drivers to your computer. To enable debugging, you need to:

Open “Settings” and go to “About the phone”.
Quickly click on the “MIUI version” line several times until you are notified that you have become a developer.
Go back and open “Advanced Settings” – “For Developers”.
Go down to ” USB debugging ” and activate the slider.

Now download the drivers and install them on your PC. On Windows 10, the necessary drivers should load automatically.

Do not skip the above steps, otherwise the computer will not recognize the connected phone!

Next, transfer the device to Fastboot:

Turn the phone off.
Press Power and Mute keys. When vibration signal sounds, release the power button and volume down knob till there a hare appears in earflaps, fixing Android. Done. We have succeeded in entering Fastboot.
Then we take the USB cable and connect the phone to the computer. Now you can start the necessary procedures with your smartphone.

Exit Fastboot

To return your mobile device to normal operation mode, you need to hold the power button for a few seconds. The smartphone will restart, and you will be able to use it. If any procedures were performed using third-party software, press “Reboot” in the utility and wait for the reboot to complete.

FAQ

What is the difference between Fastboot and Recovery?

Fastboot is only needed to connect the phone to your PC. Without a PC, it is impossible to perform any actions in Fastboot. But the Recovery works autonomously and allows you to reset the phone to factory settings and turn it to safe or repair mode. With the help of custom recovery, you can install firmware and different patches.

What should I do if my PC can’t see my smartphone in boot mode?

Ensure that the USB debugging is enabled and all required drivers are installed. Ensure the connector and cable are in good condition (it’s better to use the original cable).